Through what initiatives to help reduce the standing wave ratio of cable assemblies

Cable AssemblyWhether it is used in mobile communications or satellite earth stations, it has reliable connectivity and separation, and it can also efficiently ensure the effectiveness and consistency of transmission characteristics. In particular, those low-cost cable assembly manufacturers are rapidly establishing trade channels in multiple application fields. Now, what measures will help reduce the standing wave ratio of cable assemblies:

1. Improve the cable stripping head size

Many users are very worried about the cable assembly standing wave ratio is too large, then can improve the cable stripping head size to reduce the standing wave ratio. For example, the use of scissor-type wire stripper through the installation of size control stop, this way can not only achieve the purpose of quickly stripping the core insulation, but also can achieve the purpose of ensuring that the actual exposed size of the core is consistent, so the cable end can fully meet the requirements of terminal crimping operation.

2. Improve the welding method of components

According to a large number of experimental verification, it is shown that improving the welding method of the components will also help to reduce the standing wave ratio of the cable assembly. This is because manual scribing or welding may lead to some errors, and if the cumulative error is too large in actual production, it may lead to a rapid increase in the standing wave ratio. At this time, the purpose of efficient control of welding deformation of components is achieved by designing positioning brackets and improving welding methods.

3. Improve the test method

Reducing the standing wave ratio of the cable assembly can also be achieved by improving the test method. There are large errors in the test process of some cable assemblies, which leads to the increase of the standing wave ratio with the increase of the error. At this time, only continuous improvement of the test method can achieve the purpose of efficiently reducing the test error, and then achieve the purpose of reducing the standing wave ratio.

The low standing wave ratio and low distortion performance of cable assemblies have been widely recognized, which also promotes those cable assembly manufacturers with good quality and good reputation to gain a large number of loyal repeat customers. According to the relevant feedback, the method of reducing the standing wave ratio of the cable assembly can be achieved by improving the welding method of the assembly and improving the test method, in addition to improving the size of the cable stripping head.